Faults
Fault or fault combination
#Fault code
P0601 Unit faulty
|
The connector plug is oxidized, partially, pins are already broken.
|
Repair of oxidized connectors is possible. For this, please send us an email request beforehand.
|
Engine sometimes doesn't start, in which case there is no communication possible with the ecu and the ecu is not identified by other ecu's on the CAN-Bus
|
P0606 Engine ECU - functional failure
|
Other fault on request |
Important repair hints (!)
If you have different failures and fault codes than the faults listed on our products site, please get in touch with us before sending the unit over.
This device requires the following parts for check and repair:
- immobiliser control module
- Key